5 layer HEPA Bag for disposable bag units.
The bags are made from PP (Polypropylene) plastic (some layers are woven, others are spun-bond).
Weight g/m2 100
Air permeability l/m2.s 430
Optimum fine particle filtration
Filtration efficiency 92.4% EN1822-3 (Most Penetrating Particle Size, MPPS: Typically between 0.05 and 0.3
Dust retention of 99.98% efficiency
Note: HPB1 bag may also be used in place of the HPB2H.
Remove the lid by lifting straight up.
Remove the bag by sliding the rubber gasket that surrounds the hole in the disposable bag off the plastic inlet stem that protrudes through the side of the canister (figure 2d).
Once the bag is off of the inlet stem, seal the bag by removing the backing from the tab and cover the hole with the flap. Press the flap so that it securely seals over the hole (figure 3d).
This will help prevent dirt and dust from escaping.
Now, lift the bag from the dirt canister and place in a suitable trash container.
Take a new bag and extend it fully (figure 4d),
place it in the canister, and slide the rubber gasket onto the inlet stem until the rubber gasket drops into place in the ridge that is around the inlet stem (figure 5d).
Carefully replace the lid onto the dirt canister to ensure that it seals properly or it could cause a vacuum leak and reduce the cleaning efficiency of your system.
NOTE: This step is only required in the event that the bag breaks. If bag breakage does occur, it is necessary to lift the plate located under the bag and clean the small screen.
The filter bag should be changed or cleaned when there is 3-6 inches of dirt or anytime there is a noticeable reduction of air flow at the cleaning tool. Initially, the dirt canister should be checked or emptied weekly until some idea can be obtained as to how long it takes to half fill the canister under your normal cleaning routine. All vacuum systems will function more effectively if it is emptied frequently. Under no circumstances should you allow your dirt canister to become more than 3/4 full before emptying. (Note: The canister will fill more rapidly if NEW carpets are being cleaned for there is usually a tremendous quantity of loose fibers that are retained in the carpet from the manufacturing process. In some instances it may take several months before all of these loose fibers are removed.)